粉尘与环境研究室知识库

Urban fugitive dust samples were collected to determine the chemical profiles of fugitive dust over Xi'an. Seventy eight samples were collected and divided into categories of paved road dust, construction dust, cement dust, and soil dust. Eighteen elements, including Na, Mg, Al, Si, K, Ca, Ti, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, As, Ba, and Pb, and eight water-soluble inorganic ions, including Na+, Mg2+, Ca2+, NH4+, F-, Cl-, NO3- and SO42-, were measured. The most abundant elements in these urban dust samples were Al, Si, Ca, and Fe. Al, Si, K, and Ti and showed strong positive correlations with each other, indicating they are typical dust trace elements. In contrast, elements of Ca, Zn, As, and Pb had negative correlations to crustal elements. Si/Al, K/Al, Ti/Al, Mn/Al, and Fe/Al ratios varied insignificantly among these four samples types; these ratios are similar to the properties of loess, desert, and Gobi soil dust reported in previous studies. A significantly higher Ca/Al ratio was dominant in the chemical profile of the cement samples. In addition, high Pb/Al and Zn/Al ratios were detected in comparison with those in the Gobi soil, desert soil, and loess soil samples, which indicated that Pb/Al and Zn/Al ratios can be considered as markers of urban dust. Total water-soluble ions occupied only a small fraction (<5%) in the urban fugitive soil samples indicating that most of the materials in the fugitive dust were insoluble. Ca2+ and SO42- were the most abundant ions in all samples. Most of the Ca and K in the fugitive soil samples were in insoluble phases, which differ significantly in comparison with combustion sources. A strong correlation was observed between Ca2+ and estimated CO32- levels indicating that most of Ca2+ was in the form of CaCO3 rather than other calcium minerals in Xi'an fugitive dust.